Automotive Manual, Car Parts and News

I just bought an 92 Nissan 300ZX and today it started to overheat. So I pulled over listend and checked around on the car. It sounded like running water and boiling water, also its making a hissing sound. Whe I looked under the car its leaking fluid froumd behind the driver side tire. Anyone know [...]

[Read more →]

The installation of a turbocharger is a relatively easy way of increasing the power of an engine – it’s an alternative to increasing the size and weight of an engine. On the Figaro, the addition of a turbo about doubles the engine power – it’s therefore a vital part of the car!

[Read more →]

I was wondering what I can do that is cheap to bump up my hp on my 97 nissan pickup. I already put a K&N air filter in it, which gave it about 4 extra hp, but im looking for more hp. Also i was wondering if they make a supercharger or turbo for this [...]

[Read more →]

We recommend that this turbo upgrade kit be installed by a qualified automotive technician. If you have any doubts as to your ability to install this turbo upgrade kit, consult with a local automotive repair company. Please be sure to carefully read all of the attached instructions prior to starting the installation process. If you [...]

[Read more →]

DTC P1557 (17965) stored in DTC memory. May be caused by a loss of pressure to turbocharger due to cracks or tears in intake air duct under the fastening clamps.
Production
Improved parts installed beginning with the following Vehicle Identification Numbers.
A6Q 2.7T S4 2.7T VIN: 4B_YN090650 VIN: 8D_YA140000

[Read more →]

Installation
Please follow the directions below carefully, making sure to perform each step in its listed order. We would like to stress to you that, when the directions call for you to remove or install any of your vehicle’s factory components, you must follow the instructions given in your factory service manual.
1. Remove the factory turbocharger [...]

[Read more →]

Diesel Turbo Lifesaver (DTLS) is a computer controlled device that allows you to set an automatic engine idle sequence to properly cool your turbocharger before engine shutdown as required by Ford and Navistar. Failure to follow recommended turbo cooling procedures can lead to premature bearing failure that is NOT covered under the factory warranty. Installing [...]

[Read more →]

Read all instructions before starting any work.
1. It is suggested to lower or completely remove the spare tire from under the vehicle. This will help in the removal of the original equipment (OE) exhaust system and with the installation of the DynoMax exhaust kit.
2. Remove the existing exhaust system assembly from the vehicle. Lubricate the [...]

[Read more →]

Intercooler Assembly Installation:
1. Disconnect the negative battery cables from both batteries
2. Disconnect the inlet air temperature/ pressure sensor connector located on the air box cover. the connector is shown in Figure 1.
3.Remove the nut that fastens the air filter housing to the radiator cross brace.
4. Loosen the hose clamp that secures the air inlet duct [...]

[Read more →]

Study these instructions completely before proceeding. Engine and/or turbocharger damage may occur if any component within these instructions is improperly installed. Turbonetics, Inc or any of its distributors cannot be held responsible for damages as a result of negligent or improper installation. This complete turbocharger system can be installed using common tools and automotive procedures, [...]

[Read more →]