Automotive Manual, Car Parts and News

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. Reference the truck’s Owner’s manual.
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
NOTE: On F-150 (FD80002) make sure the OEM left side pivot cup remains on the […]

[Read more →]

Before installation of the Air Ride unit, prepare a smooth, flat, hard surface and have all tools and equipment needed for the job. Chock the front wheels of the truck, to prevent it from rolling forward or rearward. Place a jack on each side of frame ahead of the rear springs, front bolts.

[Read more →]

1. Remove the bumper and adjustable bumper mount plates from the truck frame rail. NOTE: The fascia will need to be permanently removed or notched for reinstallation. Discard mount plate hardware.
2. Install the support arms (Ref 8 & 9) to the truck frame rail. The passenger side will install behind the front stabilizer bar and […]

[Read more →]

Installation Mechanical
Step 1 Tank Install
Mount tank as high in engine compartment as possible using #8×1―” sheet metal screws and washers provided.
Optional: If windshield washer reservoir is utilized, mount quick-connect bulkhead in the bottom using “Goop” sealant or similar methanol resistant adhesive/sealant.
The following procedure will allow the use of a nut on both sides of bulkhead […]

[Read more →]

Do not attempt to manually extend or retract the mirrors. They should be moved under their motor power only!
Tools required for the installation are: 10mm deep socket, a 10mm open end wrench, trim panel remover, Philips screwdriver, razor knife, and torque inch pound wrench. For model 7005TK, a volt meter will be necessary. If you […]

[Read more →]

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 10-1/2″ from the center of the push beam to level ground. DO NOT exceed 12-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

1. Disconnect the negative battery cable, then, loosen the hose clamp on the factory intake tube. Disconnect the electrical connector from the Mass Air Sensor and unclip the wiring from the air box lid.
2. Unclip the factory air box lid from the base and remove from engine compartment. Remove original flat panel filter.
3. Using a […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
PUSHBEAM HEIGHT
The recommended pushbeam height for this undercarriage assembly is 10-1/2″ from the center of the pushbeam to level ground. DO NOT exceed 12-1/2″ […]

[Read more →]