Automotive Manual, Car Parts and News

1. Take Parts A-F and assemble them together as shown on Diagram A with the straight pin installed. IMPORTANT NOTE: Part D is a critical safety component. Notice the tabs on the part. Which ever side you are placing the Tool Box Step on your vehicle, the tabs on Part D must be facing down […]

[Read more →]

The vehicle should only be engaged in 4 Wheel Drive for off-road operation or when road or weather conditions create poor traction. When you are operating the vehicle on DRY roads keep the transfer case in 2H to prevent excessive tire wear and drive train damage.
ENGAGE FOUR WHEEL DRIVE WITH – MANUAL LOCK-OUT HUBS
1. Prepare […]

[Read more →]

Ride Height
1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspension, the vehicle should be driven forward at least 10 feet immediately prior to taking these measurements. Ride height is the measurement from the center of the axle straight up (vertical) to the fender lip. Record this […]

[Read more →]

Step 1: (A) Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key at the rear of the torsion bar under the cab of […]

[Read more →]

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

[Read more →]

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor liner. However, do not remove the factory-installed carpeting. Your liner is made from […]

[Read more →]

1) Disconnect the battery.
2) Remove fender:
Remove all Phillip’s screws or fasteners from the wheel well. Usually you will have to remove bolts to loosen the bumper Remove all bolts from the bottom of the fender by the door. Remove bolts from the top of the fender. Usually you will have to remove (1) bolt holding […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall […]

[Read more →]

Getting started
- Chock the other 3 wheels on both sides
- Release handbrake
- Put the gearbox into neutral
- Loosen wheel nuts
- Jack up the car
- Remove wheel nuts + wheel
- Place jack-stand under car for safety

[Read more →]

1. Install one Miata Lo-Pro Headlight con- version at a time starting with the Drivers side first. Please note that when “Right” or “Left” is mentioned, it is referenced from behind the steering wheel. With the headlights and the hood in the UP position remove the black plastic mask by removing the four phillips (cross) […]

[Read more →]