Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

1998-2005 Audi C5 Wheel Bearing Unit, Removing and Installing

November 7th, 2010 · No Comments

Removing
Remove decorative wheel cover, for light-alloy wheels pull off protective cap (use pulling hook in vehicle tool kit). Remove bolt for driveshaft. (Only remove when vehicle is standing on its wheels: danger of accident). Remove wheel. Secure brake rotor using a wheel bolt. Remove bolt. Pull cable of ABS wheel speed sensor out of bracket [...]

[Read more →]


Audi A6/C5 Brake System Servicing

October 30th, 2010 · No Comments

Front brakes (FN-3), servicing
Note: Install complete repair kit.
After replacing brake pads and before moving vehicle, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.
When siphoning brake fluid, always use a bleeder bottle that is used exclusively for brake fluid. Brake fluid is poisonous. NEVER siphon brake fluid with [...]

[Read more →]


2000-2005 Lincoln Aviator, Ford Explorer Wheel Bearings Removal and Installation

June 1st, 2010 · No Comments

Do not loosen the axle wheel hub retainer until the wheel and tire are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied. NOTE Have an assistant press the brake pedal to keep the axle from turning. 1. Before servicing the vehicle, [...]

[Read more →]


1991 Infiniti G20 Axle Shafts – Front Removal & Installation

May 20th, 2010 · No Comments

Axle shafts transfer power from transaxle to drive wheels. Axle shafts consist of a shaft and flexible Constant
Velocity (CV) joint at each end. See Fig. 1 . Inner CV joint is splined to transaxle. Outer CV joint is splined to
hub assembly and secured by wheel bearing lock nut.
Inner CV joint is a plunging tripod joint. [...]

[Read more →]


02-05 Dodge 1500 4WD 6″ Suspension System Installation Instructions

December 15th, 2009 · No Comments

Each lift kit, and options to lift kits, are packaged separately. Therefore installation procedures are covered in separate instructions. Familiarize yourself with each specific set of instructions before beginning.
INTRODUCTION
• Installation by a professional mechanic is recommended. Use of the appropriate tools, a Dodge service manual, and a shop hoist can greatly reduce installation time.

[Read more →]




?>