Automotive Manual, Car Parts and News

1. Start by disconnecting the wire harness from the MAF sensor as shown.
2. Next loosen the hose clamp that attaches the stock air tube to the stock air box as shown.
3. Remove the bolt that holds the stock air box in place and set aside for reuse with the MAC air system.
4. Next remove the […]

[Read more →]

In the vast majority of cases, the manifold may be installed without modifications, if further port matching is required, material removal should be blended up at least two inches into the runner. Since the casting lines between the runners and the plenum floor are located entirely outside of the runner entries, an ideal runner approach […]

[Read more →]

1. For ease of installation of your Banks High-Ram Intake, please familiarize yourself with the procedures by reading the entire manual before starting work. This instruction manual contains 8 pages of text, and 6 illustrations.
2. Disconnect the ground cable from the battery before beginning work. If there are two batteries, disconnect both.
3. Route and tie […]

[Read more →]

On this particular model vehicle, there is not splashguard underneath the vehicle. This means that the air filter is exposed to the outside elements. Extreme care must be taken while driving the vehicle in the rain. If you have to traverse any deep water, do so with extreme caution. If rains are intense, it may […]

[Read more →]

Dodge Nitro Subwoofer Installation
1. Find the fuse block under the hood and open the fuse box cover.
2. Using a 13mm socket and ratchet loosen and remove the fuse box power supply nut. Fig. 1
3. Connect the ring terminal of the power harness to the fuse box power lug and retighten the nut.
4. Route the wire […]

[Read more →]

Intercooler Assembly Installation:
1. Disconnect the negative battery cables from both batteries
2. Disconnect the inlet air temperature/ pressure sensor connector located on the air box cover. the connector is shown in Figure 1.
3.Remove the nut that fastens the air filter housing to the radiator cross brace.
4. Loosen the hose clamp that secures the air inlet duct […]

[Read more →]

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel […]

[Read more →]

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS […]

[Read more →]

1) Disconnect the battery.
2) Open door completely and loosen the door catch that is attached to the inner frame and the door. Later we’ll remove it.
3) Remove fender:
Remove all 6 screws that are attached to the inner fender well.
Remove (2) 10mm bolts that secure the bumper to the fender.
After removing the (2) 10mm bolts you […]

[Read more →]

1. Disconnect the negative battery cable, then, loosen the hose clamp on the factory intake tube. Disconnect the electrical connector from the Mass Air Sensor and unclip the wiring from the air box lid.
2. Unclip the factory air box lid from the base and remove from engine compartment. Remove original flat panel filter.
3. Using a […]

[Read more →]