Automotive Manual, Car Parts and News

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Remove the battery cover and disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.

[Read more →]

GENERAL NOTES:
1. THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC.
2. Compare all contents of the boxes to the parts list before starting to insure all components are included.
3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts […]

[Read more →]

The Auxiliary Idle Control Module, also called Auxiliary Powertrain Control Module (APCM), is for use in Light Trucks equipped with 7.3L DIT Diesel engines. Each kit includes an Auxiliary Idle Control module, wiring harness, mounting bracket and hardware, operator’s card, and this instruction booklet.
CHARGE PROTECTION
Charge Protection is used for maintaining battery charge. In Charge Protection […]

[Read more →]

Thank you for purchasing the Ford 7.3L Juice Module for the Ford Powerstroke Dieselо. The Juice module has been developed and produced from the highest quality materials available to ensure the best performance for years to come.
Please read these instructions through completely and thoroughly understand each step prior to installation. Warning: This product will not […]

[Read more →]

Installation instructions for the Mitsubishi Montero
- Locate and remove two vertical Phillips screws above the display panel. With Dash Trim Tool (#SIT-104), locate and release six (6) clips that secure the trim bezel. Remove bezel and disconnect emergency flasher wiring harness from the back of the bezel. Set bezel aside carefully.
- Locate and remove the […]

[Read more →]

To begin the installation of your new Adrenaline box, first make sure the ignition is in the off position and key is removed from the ignition. We also recommend disconnecting your batteries for extra safety.* When routing wires pay special attention to avoid any moving, sharp, or hot engine components! Now choose a suitable mounting […]

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

PRE-INSTALLATION NOTES
1. Special literature required: OE Service Manual for model/year of vehicle. Refer to manual for proper disassembly/reassembly procedures of OE and related components.
2. Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the OE manual.
3. Larger rim and tire combinations may increase leverage on suspension, steering, and related components. When […]

[Read more →]

Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]